1/2" membrane valve, 2-way, normally closed (NC), for fluid use, indirect drive. Body: INOX AISI 316.
Hole diameter: 13 mm
Compatible coils for this type of electrovalve are range MA30 (30mm) (Coil and connector not included)
The main hole of the valve body is opened by the effect of an imbalance between the upper and lower surfaces of the membrane, when the coil is not activated, there is pressure in the upper chamber of the membrane, while in the lower chamber there is only pressure in the main hole of the valve , keeping it closed. When we give tension to the coil, we set the moving core in motion, opening the piloting hole and doing the discharge of fluid from the upper chamber, the pressure difference at this time causes it to open the main hole.
In this type of electrovalves there must be a small pressure difference between the inlet and the outlet for it to work properly.
specifications:
- Manufacturer: Aignep
- Reference: RSP-15J
- Type of control: indirect drive.
- Thread size: 1/2".
- number of tracks: 2.
- number of positions: 2.
- Configuration: 2/2 closed (NC).
- Body: INOX AISI 316.
- Guide tube, cores and spring: Inox.
- Type of gasket: FKM.
- Type of fluids: Press and press on air, water (max. 75ºC), mineral oils, diesel, fuel oil.
- Maximum pressure: 13 bar.
- Iso 228 size: 1/2".
- Ø step: 13.
- Minimum pressure differential (ΔP bar): 0.5 bar.
- Maximum pressure differential (ΔP bar): 13
- Working temperature of the electrovalve: -10ºC to +80ºC.
- Fluid temperature: -10ºC to +140ºC.
- Installation: Never with the coil down.
Material for professional use, install respecting the regulations in force at the place of installation.
For more information you can download the technical data sheet by clicking on the "Attachments" tab
English 
Español
Português PT
Français
Italiano
Deutsch
